Brother NX 600 - Manual (Page 126)

UTILITY STITCHES
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
120
Changing the stitch density
If a decorative satin stitch has been selected, the
stitch density can be changed.
a
Select a decorative satin stitch .
b
Press (Settings key) in the operation panel.
X The settings screen appears.
c
Press , , and (Arrow keys) until
is selected.
d
Press (OK key).
X The screen for specifying the stitching
density of the decorative satin stitch appears.
e
Press and until the desired density is
selected.
Select
for coarser stitching or select for
finer stitching.
f
Press (OK key).
X The initial stitch screen appears again, and
the stitching density is changed.
CAUTION
Changing the pattern length
The length of one part of a satin stitch can be set to
one of five sizes.
a
Select a satin stitch .
b
Press (Settings key) in the operation panel.
X The settings screen appears.
c
Press , , and (Arrow keys) until
is selected.
d
Press (OK key).
X The screen for changing the length of a satin
stitch appears.
e
Press and until the desired ratio is
selected.
The length can be set within the range of
and .
X The satin stitch length is changed.
f
Press (OK key).
X The initial stitch screen appears again.
● If the stitching density is too fine,
depending on the needle, the stitches may
be bunched together, causing the needle
to break.
F3dash-BrotherE_sgml.book Page 120 Friday, September 5, 2003 5:46 PM