Brother NX 600 - Manual (Page 87)

Buttonhole Stitching 81
3
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Button sewing
Buttons can be sewn on with the sewing machine.
Buttons with 2 or with 4 holes can be attached.
a
Raise the presser foot lever, and then slide the
drop feed lever, located at the rear of the
machine on the base, to
(to the right as
seen from the front of the machine).
a Drop feed lever (as seen from the rear of the
machine)
b Back side
X The feed dogs are lowered.
b
Attach button-sewing foot "M".
• For details, refer to "Replacing the presser
foot" (page 37).
c
Place the button into button-sewing foot "M".
a Button
• When attaching four-hole buttons, first sew
the two holes closest to you. Then, slide the
button so that the needle goes into the two
holes toward the rear of the sewing machine,
and then sew them in the same way.
d
Select stitch
55
.
• For details, refer to "Selecting stitching" (page
66).
• Leave automatic thread-cutting set to .
e
Turn the balance wheel toward you to check
that the needle correctly goes into the two
holes of the button.
Adjust the stitch width to the distance between
the button holes.
1
2
1
F3dash-BrotherE_sgml.book Page 81 Friday, September 5, 2003 5:46 PM