Brother NX 600 - Manual (Page 21)

Changing the Machine Settings 15
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
■ List of stitch or machine attributes
The stitch or machine attributes that can be set are listed below. For details on each attribute, refer to the
corresponding reference page.
Attribute Icon Details Reference
Thread tension Adjusts the tension of the upper thread. page 53
Automatic
reverse/
reinforcement
stitching
Specifies automatic reverse/reinforcement stitching. page 57
Automatic
thread-cutting
Specifies automatic thread-cutting. page 58
Check pattern Allows combined patterns to be checked. page 118
Left/right
mirror imaging
Mirror images patterns along a vertical axis. page 122
Pattern length Adjusts the length of satin stitches. page 120
Pattern size Sets the size of patterns to be large or small. page 119
Repeated/
single sewing
Specifies whether the pattern will be sewn once or
repeatedly.
page 117
Stitching
density
Specifies the sewing density of the stitching. page 120
Save settings
Allows adjusted thread tensions and pattern widths
and lengths to be saved.
page 60
Needle
position
Specifies where the needle is positioned when the
sewing machine is stopped.
page 16
Twin needle
sewing
Specifies the twin needle. page 28
Stitch width
control
Allows the stitch width to be adjusted with the sewing
speed controller.
page 98
Language
Allows the language used in the screens to be
changed.
page 17
Buzzer
Specifies whether or not a beep is sounded with each
operation.
page 148
LCD brightness Adjusts the brightness of the LCD. page 16
Vertical pattern
adjustment
Adjusts the up and down position of the pattern. page 124
Horizontal
pattern
adjustment
Adjusts the left and right position of the pattern. page 124
F3dash-BrotherE_sgml.book Page 15 Friday, September 5, 2003 5:46 PM