Brother NX 600 - Manual (Page 154)

APPENDIX
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
148
Operation beep
Each time a key is pressed or an incorrect operation is
performed, a beep is sounded.
■ For a correct operation
One beep is sounded.
■ If an incorrect operation is performed
Two or four beeps are sounded.
■ If the machine locks up, for example, because
the thread is tangled
The sewing machine continues to beep for four
seconds. The machine automatically stops.
Be sure to check for the cause of the error, and
correct it before continuing to sew.
Cancelling the operation beep
When the sewing machine is purchased, it is set to
beep each time an operation panel key is pressed.
This setting can be changed so that the machine does
not beep.
a
Turn on the sewing machine.
X The LCD comes on.
b
Press (Settings key) in the operation panel.
X The settings screen appears.
c
Press , , and (Arrow keys) until
is selected.
d
Press (OK key).
X The screen for changing the beep setting
appears.
e
Press to select .
To return to , press .
X The machine is now set so that it will not
beep.
f
Press (OK key).
X The initial stitch screen appears again.
F3dash-BrotherE_sgml.book Page 148 Friday, September 5, 2003 5:46 PM