Brother NX 600 - Manual (Page 26)

GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
20
CAUTION
h
While holding the spool with your right hand,
pull the thread with your left hand, and then
pass the thread behind the thread guide cover
to the front.
a Thread guide cover
i
Pass the thread under the thread guide plate
from the right.
a Thread guide plate
j
Pull the thread to the right, pass it under the
hook on the thread guide for bobbin winding,
and then wind it counterclockwise between
the discs.
a Thread guide for bobbin winding
k
While using your left hand to hold the end of
the thread that wraps around the thread guide
for bobbin winding, use your right hand to
wind the free end of the thread clockwise
around the bobbin four or five times.
l
Pull the thread to the right and pass it through
the slit in the bobbin winder seat.
a Slit in bobbin winder seat (with built-in cutter)
X The thread is cut to a suitable length.
● If the spool or the spool cap is not
positioned correctly, the thread may
become tangled around the spool pin or
the needle may break.
● Three spool cap sizes are available (large,
medium and small), allowing you to
choose a spool cap that best fits the size
of spool being used. If the spool cap is too
small for the spool being used, the thread
may catch on the slit in the spool or the
needle may break.
1
1
1
1
1
F3dash-BrotherE_sgml.book Page 20 Friday, September 5, 2003 5:46 PM