Asus TS300-E3 - Manual (Page 117)

A S U S T S 3 0 0 - E 3 A S U S T S 3 0 0 - E 3 A S U S T S 3 0 0 - E 3 A S U S T S 3 0 0 - E 3 A S U S T S 3 0 0 - E 3 5 - 3 1 5 - 3 1 5 - 3 1 5 - 3 1 5 - 3 1
Restore on AC Power Loss [Last State] Restore on AC Power Loss [Last State] Restore on AC Power Loss [Last State] Restore on AC Power Loss [Last State] Restore on AC Power Loss [Last State]
When set to Power Off, the system goes into off state after an AC power
loss. When set to Power On, the system goes on after an AC power loss.
When set to Last State, the system goes into either off or on state,
whatever the system state was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Resume On Ring [Disabled] Resume On Ring [Disabled] Resume On Ring [Disabled] Resume On Ring [Disabled] Resume On Ring [Disabled]
When set to [Enabled], the system enables the RI to generate a wake
event while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On LAN [Disabled] Resume On LAN [Disabled] Resume On LAN [Disabled] Resume On LAN [Disabled] Resume On LAN [Disabled]
When set to [Enabled], the system enables the LAN to generate a wake
event while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On PME# [Disabled] Resume On PME# [Disabled] Resume On PME# [Disabled] Resume On PME# [Disabled] Resume On PME# [Disabled]
When set to [Enabled], the system enables the PME to generate a wake
event while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On RTC Alarm [Disabled] Resume On RTC Alarm [Disabled] Resume On RTC Alarm [Disabled] Resume On RTC Alarm [Disabled] Resume On RTC Alarm [Disabled]
Allows you to enable or disable RTC to generate a wake event.
Configuration options: [Disabled] [Enabled]
The following items appear when the P o w e r O n R T C A l a r m P o w e r O n R T C A l a r m P o w e r O n R T C A l a r m P o w e r O n R T C A l a r m P o w e r O n R T C A l a r m item is
set to Enabled.
RTC Alarm Date (Days)
To set the alarm date, highlight this item and press the <+> or <->
key to make the selection. Configuration options: [Everyday] [1] [2]
[3]... ~ [31]
System Time
To set the alarm hour, highlight this item and press the <+> or <->
key to make the selection. Configuration options: [00] [1]... ~ [23]