Brother QL-720NW - Manual (Page 37)

P-touch Template Command Reference
- 32 -
7. Control Command Details
^CO Select printer settings (cut options)
ASCII: ^ C O n1 n2 n3 n4
Decimal: 94 67 79 n1 n2 n3 n4
Hexadecimal: 5E 43 4F n1 n2 n3 n4
Parameters
0≤n1≤1
0≤n2≤9
0≤n3≤9
0≤n4≤1
Description
 Specifies the various cut options.
n1: Auto cut setting
(ON: 1 (default); OFF: 0)
(n2*10)+n3: Auto cut label number setting (1 to 99)
(Default value: 1)
n4: Cut at end setting
(ON: 1 (default); OFF: 0)
 This command is a dynamic command.
Remarks
 The auto cut label number setting can be between 1 and 99.
This command becomes invalid if any other value has been specified.
Example
 To cut after every two labels:
Since the auto cut setting will be set to ON and the auto cut label number will be two labels, n1=1, n2=0
and n3=2. Therefore, the command will be as follows.
^ C O 1 0 2 0
(5Eh 43h 4Fh 31h 30h 32h 30h)