7 special control parameters, 8 communication option – Sterlco SF1000 Gravimetric Additive Feeder User Manual
Page 28

28
5.7 Special Control parameters (for Maintenance crew use only)
Enter Maintenance screen
Press
key to display "Special Control
Parameters" screen
Note: These parameters are important for maintenance purposes, but not for current normal
operation
Last Shot
Last shot weight delivered by Sterling SF-1000
Back Time
Last IMM's time as sensed and measured in "Sensor" input
- unrelated to mode operation
Last Max Flow Last calculated Max Flow parameter value
Weight
Material Weight in Sterling SF-1000 hopper
Speed
Motor's speed during the next cycle
5.8 Communication
Option
If the communication TCP/IP option is used, the equipment IP Address as well as the Gate
Address should be updated.
Note: You need to open the password to enter the Communication screen, (see Appendix B
for password opening procedure).
Open password
Enter Maintenance screen and press "0"
–
"Communication" screen will be displayed
Enter IP Address
Enter Gate Address
Press
parameters
Shut-off controller to finalize update