3 starting sequence, 1 main screen for mode "0" (gravimetric mode) – Sterlco SF1000 Gravimetric Additive Feeder User Manual
Page 14

14
4.3 Starting sequence
Switch on the Power main switch
At first the initial screen will be displayed,
showing the present control software and
language versions now in use
Enter Maintenance Screen (see 4.4) and
press
key if you wish to check the Version No. again later during operation
Press <ESC> key to return to main screen
Note:
If the hopper is empty, the Venturi loader will perform an automatic filling sequence soon
after the first operating, unless the MB % has been set to "0".
After a few seconds, the “Main Screen” will be displayed.
Main screen view depends on current selected Working Mode:
4.3.1 Main Screen for Mode "0" (Gravimetric Mode)
Shot Weight: Injected batch weight, including
the cold runner (gr.)
Desired: Desired MB/Additives %
Actual: Measured MB/Additives %
Speed: Motor Speed in % of max. rate
Weight: Weight of material in SF-1000
hopper (gr.)
Press
key to enter Totals screen
Press
key to enter Maintenance screen
Press
key to enter Fill / Empty screen
4.3.2 Main Screen for Mode "1" (Gravimetric Mode, with constant feeding time)
Shot Weight: Injected batch weight, including
the cold runner (gr.)
Desired: Desired MB/Additives %
Actual: Measured MB/Additives %
Speed: Motor speed in % of max. rate
Weight: Weight of material in SF-1000
hopper (gr.)
Press
key to enter Time selecting screen, to manually set constant feeding time
Press
key to enter Maintenance screen
Press
key to enter Fill / Empty screen