beautypg.com

Replacing the mtl-30 battery – Dwyer GDL-T User Manual

Page 20

background image

DwyerLog User’s Guide

Version 1.4x

20/33

Replacing the MTL-30 Battery

The battery level of the MTL-30 can be checked using the DwyerLog software, by opening the Logger Status
window. It is suggested that the battery is replaced when the battery level reaches yellow. When the battery level
reaches red, it is imperative that the battery is replaced as soon as possible. When the battery level is too low, the
logger will stop logging automatically, resulting in data not being recorded. The DwyerLog software will give you a
warning if you try to start a logging session while the battery is low.

To replace the battery follow these steps:

1. Disconnect the logger from the USB cable. Do not replace the battery while the USB cable is connected!

2. Using a screwdriver, remove the screw in the back of the logger.

3. Remove the logger from the case.

4. Using a pen or a pencil, push the battery out of the casing, then use your fingers to slide the battery out

Avoid using pliers as they will short the battery.

5. Press and hold the logger button for about 2 seconds. This step removes any extraneous charge from the

logger system. This step is very important. The logger may not operate correctly if this step is not
performed.

6. Slide the new CR2032 battery into the battery case. Make sure that the + indicator on the battery matches

the + indicator on the battery case.

7. When the battery is replaced correctly, the LED will flash a single green flash for about 1 second.

8. Place the logger back in the case and replace the screw.

General guidelines as to how long a battery will last is shown in the table below. It is assumed that the logger uses a
fresh CR2032 battery, and is setup for continuous logging with rollover enabled.

Logging Interval Battery Life

1 Second

4 Months

5 Seconds

17 Months

10 Seconds

2.5 Years

30 Seconds

4.5 Years

1 Minute

6 Years

2 Minutes

7 Years