APC Smart-UPS VT - Manual (Page 30)

Configuration – Settings
24 Smart-UPS® VT 10-40 kVA 400V, 208V, 200V – Operation 990-2282A-001
The Beeper setup. In the Beeper setup you can choose between the following options:
• Never: If you select this setting, the Beeper will be active at internal UPS errors only.
• PwrFail+30: If you select this setting, the Beeper will be active at internal UPS errors and at utility/
mains or bypass errors. The Beeper will only sound if the fault has been present for more than 30
seconds.
• PwrFail: If you select this setting, the Beeper will be active at internal UPS errors and at utility/
mains or bypass errors. The Beeper will sound immediately when the error is occurring.
• L OW B ATT : If you select this setting, the Beeper will be active at internal UPS errors at utility/
mains or bypass errors, at power failures, and at a low battery level (if the UPS runs in battery
operation).