APC Smart-UPS VT - Manual (Page 18)

Operation – Operation Procedures
12 Smart-UPS® VT 10-40 kVA 400V, 208V, 200V – Operation 990-2282A-001
How to turn load OFF/ON via the display interface
Turn Load OFF – How to disconnect the UPS output to the load equipment.
Turn load ON – How to connect the UPS output to the load equipment.
Warning
Disconnecting the UPS output to the load does NOT de-energize the UPS! Always follow
the total power off procedure if you need to de-energize the UPS in emergency
situations, see section How to perform a total power off!
 
 
 If the UPS is running in parallel operation
this procedure must be carried out on each
UPS.
 
 
 If the UPS is running in parallel operation
this procedure must be carried out on each
UPS.
Chrg 100%
Load 000%
xxxVin 000Vout x0Hz
Runtime: 0hr 0m
Press
Control
Status
Setup Logging
Display
Diags
Help
Use Press
Turn Load Off
Press Use
Confirm:
Turn Load OFF
NO, Abort
YES, Turn Load OFF
Use Press
Chrg 100%
Load 000%
xxxVin 000Vout x0Hz
Runtime: 0hr 0m
Press
Control
Status
Setup Logging
Display
Diags
Help
Use Press
Turn Load On
Press Use
Confirm:
Turn Load OFF
NO, Abort
YES, Turn Load ON
Use Press