Dwyer UFB - Manual (Page 19)

3: Operating Procedures
15
3: Operating Procedures
QUICK START
Enter data
Attach sensors
FLOW READING
Carry out any necessary calibration (Paragraph 3.3)
How to adjust the Zero Flow Offset – Paragraph 3.3.2
How to adjust the Calibration Factor – Paragraph 3.3.3
How to adjust the Roughness Factor – Paragraph 3.3.4
How to adjust the Damping Factor – Paragraph 3.3.5
Set-up a monitoring
(Paragraph 3.4)
How to measure totalized flows – Paragraph 3.5
Operation with an Energy Meter – Paragraph 3.7
Configure the interfaces
(Paragraph 3.4)
Set date/time, Language
Initial instrument setup ( Paragraph 3.1 )
Connect and take basic flow readings ( Paragraph 3.2 )
4-20mA ON/OFF – Paragraph 3.4.1
4-20mA Calibration – Paragraph 3.4.1
Pulse ON/OFF – Paragraph 3.4.2
Pulse calibration – Paragraph 3.4.2
Alarm outputs – Paragraph 3.4.3