beautypg.com

Caleffi 112 User Manual

Page 13

background image

Se le valvole di bilanciamento con flussometro incorporato non sono installate,

messe in servizio e mantenute correttamente secondo le istruzioni contenute in

questo manuale, allora possono non funzionare correttamente e possono porre

l’utente in pericolo.

Pulire le tubazioni da eventuali detriti, ruggini, incrostazioni, scorie di saldatura e

da altri contaminanti.

Come in ogni circuito idraulico è importante fare attenzione alla pulizia dell’intero

sistema. Assicurarsi che tutta la raccorderia di collegamento sia a tenuta

idraulica. Per un funzionamento ottimale, l’aria contenuta nel fluido deve essere

rimossa.

Per ragioni di sicurezza, a causa dell’alta comprimibilità dell’aria, sono

sconsigliati i test di tenuta sull’intero sistema, ed in particolare sulle valvole,

tramite aria compressa.

Nella realizzazione delle connessioni idrauliche, prestare attenzione a non

sovvrasollecitare meccanicamente la filettatura del corpo della valvola.

Nel tempo si possono produrre rotture con perdite idrauliche a danno di cose e/o

persone.

Temperature dell’acqua superiori a 50°C possono provocare gravi ustioni.

Durante l’installazione, messa in servizio e manutenzione delle valvole di

bilanciamento con flussometro, adottare gli accorgimenti necessari affinché tali

temperature non arrechino pericolo per le persone.

E’ vietato farne un utilizzo diverso rispetto alla sua destinazione d’uso.

Lasciare il presente manuale ad uso e servizio dell’utente

If the balancing valves with built-in flow meter are not installed, commissioned

and serviced correctly in accordance with the instructions given in this manual,

then they might not work properly and could put the user in danger.

Clean the pipes of any debris, rust, incrustations, welding slag and any other

contaminants.

As in all hydraulic circuits it is important to pay attention to the cleanliness of the

entire system. Make sure that all connection pipes are watertight. For optimal

operation, any air in the medium must be removed.

For reasons of safety, due to the high compression capacity of air, testing the

entire system, and especially the valves, for watertightness using compressed air

is not recommended.

When making the plumbing connections, take care not to put too much

mechanical stress on the thread of the valve body.

Over time this may result in breakage, with loss of water and damage to persons

and/or property.

Water temperatures exceeding 50°C may cause severe burns.

When installing, commissioning and servicing the balancing valves with flow

meter, take the necessary precautions so that these temperatures will not be

hazardous for people.

Any use other than the intended use is prohibited.

Leave this manual for the user to refer to

Sicurezza
Safety
Sicherheit
Sécurité
Seguridad
Segurança
Veiligheid

13