Badger Meter ORION Classic (CE) - Manual (Page 18)

Page 18
11-11
ORION® CE In-Home Display (IHD)
Programming the IHD for an ORION CE Endpoint
IMPORTANT
Before programming the IHD, the following steps must be completed:
• Install the programming software. Refer to "Installing the ORION CE IHD Programming Software on the
Trimble Ranger" on page 8 if you need help.
• Set the COM port(s). Refer to "Set Up and Modification of COM Ports" on page 16 if you need help.
1. Connect the IHD unit to the Trimble Ranger USB port using the IHD custom programming cable.
2. Tap the Menu soft key. Then tap Programming.
Result: The IHD Programmer screen opens.
3. Tap the Test button.
Result: A test confirmation window opens displaying
the message "Good Connection" along with the IHD
firmware version confirming that the IHD software is
communicating with the Trimble Ranger. See
Figure 24.
Figure 23: IHD Programmer
If you receive an error instead of the Good
Connection message, check the COM port(s)
and modify as needed. Refer to "Set Up and
Modification of COM Ports" on page 18 if you
need help.
NOTE: The firmware (FW) version shown in the
window refers to the software firmware version. To
view the firmware version for the IHD unit, press and
hold the Scroll button on the IHD until the display
changes to show the IHD FW version.
Figure 24: Good Test Connection
4. Tap ok to close the Test confirmation window.