Status icons – Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities User Manual
Page 26
Status Icons
The following icons denote the status of a meter They are used for all ORION water and gas endpoints
Read
A green circle displays when the meter reading, and work items, if applicable, are received
and no problems were reported
Tamper
A red letter “T” inside a red circle indicates a potential tamper situation where the meter is
not working For example, a cut wire
A pink letter “T” inside a pink circle also indicates a potential tamper situation where the
meter is still working For example, the meter cover is removed or low battery
Encoder Error
A red letter "E" inside a red circle is used for meters equipped with encoders to indicate a
reading cannot be obtained
Potential Leak
A red starburst indicates a meter has shown continuous usage over the past 24-hour period,
which indicates a potential leak
No Usage
A pink letter "C" inside a pink circle displays when the meter has not registered water usage
for 30 days
Reverse Flow
A pink letter "R" inside a pink circle is used for meters equipped with an encoder when the
current reading is lower than the previous reading
Out of Route
A pink question mark indicates a reading has been received from an endpoint that was not
part of the route file loaded to the laptop
Unread Manual
A pink triangle denotes an unread meter equipped with technologies other than ORION
that must be read manually
Automatically Removing Meters After Reading
To remove successfully read meters from the screen automatically, change the map settings by following these steps
1 Click Settings on the main tool bar
2 Click the Map tab
3 Check the box labeled Remove Normal Read Services from Map
Result: The meter icon will disappear from the map as it is read instead of displaying a green circle.
OTEE:
N
For additional settings that control the map functions and display, refer to
ReAdING A ROuTe
Page 26
April 2014
ORION® Meter Reading System (ORS)