West Control Solutions KS 40-1 Burner - Manual (Page 9)

Maintenance manager / Error list
With one or several errors, the extended operating level
always starts with the error list. Signalling an actual en-
try in the error list (alarm, error) is done by the Err LED
in the display. To reach the error list press Ù twice.
Error list:
Operation
Operating level 9 KS40-1 burner
125
126
SP.X SG
Ada
Err
Err LED status Signification Proceed as follows
blinks Alarm due to existing error - Determine the error type in the error list via the error number
- Remove the error
lit Error removed,
Alarm not acknowledged - Acknowledge the alarm in the error list pressing key È or Ì
- The alarm entry was deleted.
off No error,all alarm entries deleted
Name Description Cause Possible remedial action
E.1 Internal error,
cannot be
removed
- E.g. defective EEPROM - Contact PMA service
- Return unit to our factory
E.2 Internal error,
can be reset
- e.g. EMC trouble - Keep measurement and power supply cables in
separate runs
- Ensure that interference suppression of contactors is
provided
FbF.1
/ 2
Sensor break
INP1 / 2
- Sensor defective
- Faulty cabling - Replace INP1 / 2 sensor
- Check INP1 / 2 connection
Sht.1
/ 2
Short circuit
INP1 / 2
- Sensor defective
- Faulty cabling - Replace INP1/ 2 sensor
- Check INP1 / 2 connection
POL.1 INP1 polarity
error
- Faulty cabling - Reverse INP1 polarity
LooP Control loop
alarm (LOOP)
- Input signal defective or not
connected correctly
- Output not connected correctly
- Check heating or cooling circuit
- Check sensor and replace it, if necessary
- Check controller and switching device
AdA.H Self-tuning
heating alarm
(ADAH)
- See Self-tuning heating error
status
- see Self-tuning heating error status
LiM.1/
2 / 3
stored limit
alarm 1 / 2 / 3
- adjusted limit value 1 / 2 / 3
exceeded
- check process
Inf.1 time limit value
message
- adjusted number of operating
hours reached
- application-specific