West Control Solutions KS 40-1 Burner - Manual (Page 38)

9.1 Resetting to factory setting
In case of faultyconfiguration, KS4x-1 can be reset to the default condition.
For this, the operator must keep the keys increment and decrement pressed during
power-on.
Then, press key increment to select
YES.
Confirm factory resetting with Enter and the copy procedure is started
(display
COPY).
Afterwards the device restarts.
In all other cases, no reset will occur (timeout abortion).
g
If one of the operating levels was blocked and the safety lock is open, reset to
factory setting is not possible.
g
If a pass number was defined (via BlueControl
®
) and the safety lock is open, but
no operating level was blocked, enter the correct pass number when prompted in
3. A wrong pass number aborts the reset action.
g
The copy procedure (
COPY) can take some seconds.
Now, the transmitter is in normal operation.
Safety hints
KS40-1 burner 38 Resetting to factory setting
ÌÈ
+ Power on
1
SP.x run
Ada
Err
torY
FAC
SP.x run
Ada
Err
no
FAC
2
È
SP.x run
Ada
Err
YES
FAC
SP.x run
Ada
Err
COPY
FAC
Ù
3 4
SP.x run
Ada
Err
8.8.8.8.
8.8.8.8.
1. 2.