Techne 3PrimeG - Manual (Page 37)

36
CREATE A NEW PROGRAM
From the Home Screen, touch the New Program
button. This will open a screen where you can build
a program by adding stages and steps and define
the temperatures and hold times.
INSERT/DELETE A STAGE
A stage is a section of a program that consists of a number of individual steps that can be cycled
(repeated) a defined number of times.
Insert a new stage
• To insert a stage in a program, touch Insert a
new stage. A stage with one step will be
inserted.
Stage 1
• Touch this to give the stage a name (optional).
Enter the name using the text entry screen.
1 cycle
• Touch this to edit the number of cycles
(repeats) for the stage. Enter the required
number of cycles then touch Back.
Temp
• Touch the temperature button to edit the
temperature of the step and add any
increment/decrement or gradient features.
Note: The minimum step temperature that can be
programmed during cycling stages is 10°C. If the
step temperature is above or below the valid
gradient range ( 3 PrimeG only) then the gradient
function is disabled.
Time
• Touch the time button to edit the hold time of
the step and to add any increment/decrement
time features.