Techne 3PrimeG - Manual (Page 33)

32
Note: It is recommended that the administrator keeps a
record of the new password.
• Touch OK to return to the Administrator menu or
Cancel to return without making any changes.
Restore Factory Settings
All changes to the instrument defaults and settings can
be removed and the unit returned to its factory settings.
• From the Administrator menu touch Restore
Factory Settings.
• Touch the None button and enter the administrator
password followed by Back.
• Touch Restore Settings and the unit will be reset to
factory defaults.
• Touch Cancel to return to the Administrator menu
without making any changes.
• Touch Back to return to the Settings menu.
PROGRAM DEFAULTS
The program default settings will apply to every new program created on the 3 Prime. However
individual programs can be edited as required.
Heated Lid
Use this to set the heated lid temperature to
approximately 10ºC higher than the hottest block
temperature in the program.
• Touch On/Off to toggle between settings.
• Touch the temperature button to set the required lid
temperature (35 to 115ºC).
Preheat lid
Set to On to pre-heat the lid before the thermal cycling
program begins. The lid will pre-heat for 2 minutes
before the program starts.
• Touch On/Off to toggle between settings.
Sample Cooling
Set to On to cool the block to 4ºC while the lid preheats.
• Touch On/Off to toggle between settings.
• Touch More Settings for further program defaults or
Back to return to the Settings menu.