Martel Electronics DMC1400 - Manual (Page 40)

38
RTD_TYPE? Returns the RTD type
RTD_WIRE Sets the number of wires used by the RTD mode.
RTD_WIRE? Returns the wire number setting used in the RTD mode
SET_CLOCK Set calibrator clock
SIM Sets the output for mA simulation
SIM? Returns the output of the mA simulation
TAG_CLEAR Clear test data for a specified tag
TAG_CLEAR_ALL Clear test data for all tags
TAG_DNLD Download tag calibration test configuration data from a PC to the
calibrator
TAG_UPLD Upload tag calibration test results to a PC from the calibrator
TAGS? Upload a list of all tag iD's to PC
TC_TYPE Sets the thermocouple type
TC_TYPE? Returns the thermocouple type
TEMP_UNIT Sets input/output temperature unit for RTD and TC
TEMP_UNIT? Returns the temperature unit for RTD and TC
TRIG Starts and stops the pulse train in pulse mode
TRIG? Returns TRIGGERED when a pulse train is on. Returns UNTRIGGERED
when the pulse train is off.
TSENS_TYPE Sets temperature sensor type.
TSENS_TYPE? Returns temperature sensor type
UPPER_MEAS Sets the measuring mode for the upper display.
U_PRES_UNIT Sets the upper pressure unit
VAL? Returns the measured values
ZERO_MEAS Zeros the pressure module
ZERO_MEAS? Returns the zero offset of the pressure module
Table 7: Parameter units
Units Meaning
MA milliamps of current
MV Voltage in millivolts
V Voltage in volts
CPM Frequency in cycles per minute
Hz Frequency in Hertz
KHz Frequency in kiloHertz
Ohms Resistance in Ohms
Cel Temperature in Celsius
Far Temperature in Fahrenheit
Psi Pressure in pounds per square-inch