Martel Electronics MasterCAL - Manual (Page 76)

MasterCAL
Users Manual
66
7. Press the Ramp softkey. The display changes to
the following:
gj41s.eps
8. Fill in the parameters as prompted. Enter the
Start Value, End Value , and Ramp Time.
9. To automatically stop ramping if a trip condition
is detected, set the
Trip Detect to Enabled , and
select Voltage or Continuity as the trip function.
10. Press the Done softkey. Note the RAMP
annunciator next to SOURCE at the top of the
display.
11. Select a low-to-high ramp or a high-to-low ramp
with the
Ramp Up/Down softkey.
12. To start ramping, press the Start Ramp softkey.
13. Ramping continues until a trip is detected (if
enabled), the ramp time expires, or you press
the
Stop Ramp softkey.