Martel Electronics MasterCAL - Manual (Page 66)

MasterCAL
Users Manual
56
Simulating RTDs
Note
Refer to Table 6 for information about RTD
(Resistance-Temperature Detector) types
supported by the calibrator.
Connect the calibrator to the instrument under test
as shown in Figure 20. The figure shows
connections for two, three, or four-wire transmitters.
For three or four-wire transmitters, use the 4-inch
long stackable jumper cables to connect the third
and fourth wires at the source V
Ω
RTD jacks.
Proceed as follows to simulate an RTD (Resistance-
Temperature Detector):
1. If necessary, press M for SOURCE mode.
2. Press t , then select RTD from the menu.
3. Press the u or d keys followed by e to
select the desired RTD type.
4. Enter the temperature you want to simulate as
prompted by the display, then press
e .