Martel Electronics MasterCAL - Manual (Page 37)

Calibrator
Setting Up the Calibrator
27
4. Press e or the Choices softkey. The
display appears as follows:
gj40s.eps
5. The ID string is shown at the bottom of the boxed
area. To erase a character, press the Back
Space softkey. To erase the whole string, press
c .
6. Press u , d , L , or R to select a character, then
press e . Use the numeric keypad if you
want to enter a number.
7. Repeat step 6 until you are satisfied with the ID
string appearing in the window.
8. Press the Done softkey.
9. Press the Done softkey or s to exit Setup
mode.