Martel Electronics MasterCAL - Manual (Page 113)

Calibrator
Quick Guide to Applications
103
If the calibrator will not turn on, check for a dead
battery or unplugged battery eliminator. If the
calibrator is receiving power, the display flashes
when you turn it on. To see if the calibrator is
receiving power, cup your hands around the display
to shield it from ambient light, and watch the display
as you press the
o button. If there is a flash, but the
calibrator does not power up normally, have the
calibrator serviced.
Service Center Calibration or Repair
Calibration, repairs, or servicing not covered in this
manual should be performed only by qualified
service personnel. If the calibrator fails, check the
nickel-cadmium battery pack first, and replace it if
needed.
Verify that the calibrator is being operated in
accordance with the instructions in this manual. If the
calibrator is faulty, send a description of the failure
with the calibrator. Pressure modules do not need to
accompany the calibrator unless the module is faulty
also. Be sure to pack the calibrator securely, using
the original shipping container if it is available. Send
the equipment postage paid and insured, to the
nearest Service Center. (Refer to the list of Service
Centers which follows.) Beta assumes no
responsibility for damage in transit.
A Beta MasterCAL calibrator covered by the
warranty will be promptly repaired or replaced (at
Beta’s option) and returned to you at no charge. See
the back of the title page for warranty terms. If the
warranty period has expired, the calibrator will be
repaired and returned for a fixed fee. If the calibrator
or pressure module is not covered under the
warranty terms, contact an authorized service center
for a price quote for repair.
How to Contact Beta:
Beta Calibrators Corporation
a unit of Martel Electronics
2309 Springlake Road, #600
Farmers Branch, TX 75234-5875
1-800-537-2181
972-241-2200
Or visit us on the World Wide Web:
www.betacalibrators.com