KROHNE CORIMASS E Series EN - Manual (Page 73)

73
6.14 User data
6.14.1 Programming the display language
The converter can display its messages and prompts in one of three languages, German,
English or French. The language may be changed using Menu 3.8.1..
Example: Setting for German language
Begin from measuring mode.
6.14.2 Password protection of menus
As mentioned in Section 5.2, access to the menus can be protected by a password. This
password protection is enabled by Menu 3.8.2. and the password itself can be altered by Menu
3.8.3.. To enable password protection and to change the password from its factory setting,
proceed as follows (Note: the password must be enabled in Fct. 3.8.2. before it can be
changed in Fct. 3.8.3.).
Begin from measuring mode
Key Display
line 1
line 2
→
Fct. (1).0 OPERATOR
↑↑
Fct. (3).0 INSTALL
→
7x
↑
Fct. 3.(8).0 USER DATA
→
Fct. 3.8.(1) LANGUAGE
→
(GB/USA)
↑
(F) French
↑
(D) German
↵
Fct. 3.8.(1) SPRACHE
German selected
↵
Fct. 3.(8).0 USER DATEN
↵↵↵
Key Display
line 1
line 2
→
Fct. (1).0 OPERATOR
→→
Fct. (3).0 INSTALL
→
7x
↑
Fct. 3.(8).0 USER DATA
→↑
Fct. 3.8.(2) ENTRY.CODE.1
→
(NO)
↑
(YES)
↵
Fct. 3.8.(2) ENTRY.CODE.1.
↑
Fct. 3.8.(3) CODE 1
→
CodE 1 ---------
any key x9 CodE 1 *********
Enter new password
CodE 1
---------
Enter the new password again