KROHNE IFC 010 Converter HART - Manual (Page 6)

HARTÆ Communications Protocol
IFC010 Command Specification Rev: 1.0 Release Date: 29 May 1997
© 1997 KROHNE Mefltechnik D-47058 Duisburg Page 6
134 Read Low Flow Cutoff Control and Values
138 Read Analog Output Function
142 Read Pulse Output Parameters
144 Read Indication Function and Tripping Point
146 Read Primary Constant and Flow Direction
148 Read Language and User-Defined Unit
154 Read RS485 Communication Parameters
CONFORMANCE CLASS #4
- COMMON-PRACTICE
34 Write Primary Variable Damping Value
35 Write Primary Variable Range Values
36 Set Primary Variable Upper Range Value
38 Reset Configuration Changed Flag
40 Enter/Exit Fixed Primary Variable Current Mode
42 Perform Master Reset
66 Enter/Exit Fixed Analog Output Mode
- TRANSMITTER-SPECIFIC
136 Stop/Resume Totalizers
137 Reset Totalizers
150 Enable/Disable Password Protection
152 Quit Errors
CONFORMANCE CLASS #5
-UNIVERSAL
6 Write Polling Address
17 Write Message
18 Write Tag, Descriptor, Date
19 Write Final Assembly Number
- COMMON-PRACTICE
43 Set Primary Variable Zero
44 Write Primary Variable Units
45 Trim Primary Variable Current DAC Zero
46 Trim Primary Variable Current DAC Gain
51 Write Dynamic Variable Assignments
53 Write Transmitter Variable Units
59 Write Number of Response Preambles
67 Trim Analog Output Zero
68 Trim Analog Output Gain
- TRANSMITTER-SPECIFIC
131 Write Meter Diameter
135 Write Low Flow Cutoff Control and Values
139 Write Analog Output Function
143 Write Pulse Output Parameters
145 Write Indication Function and Tripping Point
147 Write Primary Constant and Flow Direction
149 Write Language and User-Defined Unit
151 Control Zero Calibration
155 Write RS485 Communication Parameters
4. Additional Response Code Information
FIRST BYTE
4.1 Transmitter-Specific Command Error
Response code value 6 for IFC010 is not implemented. The IFC010 will respond and execute all commands at any time.