KROHNE IFC 010 Converter HART - Manual (Page 17)

HARTÆ Communications Protocol
IFC010 Command Specification Rev: 1.0 Release Date: 29 May 1997
© 1997 KROHNE Mefltechnik D-47058 Duisburg Page 17
0 No Command-Specific Errors
1-4 Undefined
5 Too Few Data Bytes Received
6 Undefined
7 In Write Protect Mode
8 Update Failure
9-127 Undefined
8.8 Command #137 Reset Totalizers
Clears (sets to zero) both totalizers.
REQUEST DATA BYTES
NONE
RESPONSE DATA BYTES
NONE
COMMAND-SPECIFIC RESPONSE CODES
0 No Command-Specific Errors
1-6 Undefined
7 In Write Protect Mode
8 Update Failure
9-15 Undefined
16 Access Restricted
17-127 Undefined
8.9 Command #138 Read Analog Output Function
Reads the function of current/pulse output.
REQUEST DATA BYTES
#0
ANALOG
OUTPUT
NUMBER
CODE
RESPONSE DATA BYTES
#0 #1
ANALOG ANALOG
OUTPUT OUTPUT
NUMBER FUNCTION
CODE CODE
Data Byte #0 Analog Output Number Code, equals м1о for current output and м2о - for p ulse output
Data Byte #1 Analog Output Function Code:
0 - Off,
1 - 1 Dir, output traces flowrate measurements only in one direction,
3 - 2 Dir, output traces flowrate measurements in both directions.
COMMAND-SPECIFIC RESPONSE CODES
0 No Command-Specific Errors
1 Undefined
2 Invalid Selection