KROHNE IFC 010 Converter HART - Manual (Page 24)

HARTÆ Communications Protocol
IFC010 Command Specification Rev: 1.0 Release Date: 29 May 1997
© 1997 KROHNE Mefltechnik D-47058 Duisburg Page 24
#9 #10 #11 #12
VOLUME VOLUME
UNIT UNIT
FACTOR FACTOR
MSB MSB
#13 #14 #15 #16
TIME TIME
UNIT UNIT
FACTOR FACTOR
MSB LSB
RESPONSE DATA BYTES
#0 #1 ... #5
DISPLAY VOLUME VOLUME
LANG UNIT UNIT
CODE TEXT TEXT
BYTE #0 BYTE #4
#6 #7 #8
TIME TIME
UNIT UNIT
TEXT TEXT
BYTE #0 BYTE #2
#9 #10 #11 #12
VOLUME VOLUME
UNIT UNIT
FACTOR FACTOR
MSB MSB
#13 #14 #15 #16
TIME TIME
UNIT UNIT
FACTOR FACTOR
MSB LSB
Data Byte #0 Language:
0 - Gr.Britain/USA
1 - German
2 - French
3 - Purchased
Data Byte #1-#5 ASCII-text, specifying volume unit.
Data Byte #6-#8 ASCII-text, specifying time unit.
Data Byte #9-#12 Scaling factor for volume unit, relative to cubic meters, IEEE 754. Refer to Table 9.4,
Factors for Volume.
Data Byte #13-#16 Scaling factor for time unit, relative to seconds, IEEE 754. Refer to Table 9.5, Factors for
Time.
NOTE: For ASCII-strings the following characters are allowed (i.e. will be interpreted by display module): A..Z, a..z,
0..9 and underscore symbol м_о. Each text-field should be completely filled with acceptable symbols: say, for ìhoursî
time unit мhr_о-specifier should be used instead of ìhrî.
CAUTION: Scaling factors are not checked by transmitter and must not be zeroes!
COMMAND-SPECIFIC RESPONSE CODES