Transmitter-specific commands 13 – KROHNE IFC 010 Converter HART User Manual
Page 3
HARTÆ Communications Protocol
IFC010 Command Specification Rev: 1.0
Release Date: 29 May 1997
© 1997 KROHNE Mefltechnik D-47058 Duisburg
Page
3
7.4 Command #40 Enter/Exit Fixed Primary Variable Current Mode
9
7.5 Command #43 Set Primary Variable Zero
9
7.6 Command #44 Write Primary Variable Units
9
7.7 Command #45 Trim Primary Variable Current Dac Zero
10
7.8 Command #46 Trim Primary Variable Current Dac Gain
10
7.9 Command #48 Read Additional Transmitter Status
10
7.10 Command #50 Read Dynamic Variables Assignments
11
7.11 Command #51 Write Dynamic Variables Assignments
11
7.12 Command #53 Write Transmitter Variable Units
12
7.13 Command #62 Read Analog Outputs
12
7.14 Command #66 Enter/Exit Fixed Analog Output Mode
12
7.15 Command #67 Trim Analog Output Zero
12
7.16 Command #68 Trim Analog Output Gain
12
8. TRANSMITTER-SPECIFIC COMMANDS
13
8.1 Command #128 Read Hardware Information
13
8.2 Command #129 Read Device Implementation Code
13
8.3 Command #130 Read Meter Diameter
14
8.4 Command #131 Write Meter Diameter
14
8.5 Command #134 Read Low Flow Cutoff Control And Values
15
8.6 Command #135 Write Low Flow Cutoff Control And Values
15
8.7 Command #136 Stop/Resume Totalizers
16
8.8 Command #137 Reset Totalizers
17
8.9 Command #138 Read Analog Output Function
17
8.10 Command #139 Write Analog Output Function
18
8.11 Command #142 Read Pulse Output Parameters
18
8.12 Command #143 Write Pulse Output Parameters
19
8.13 Command #144 Read Indication Function And Tripping Point
20
8.14 Command #145 Write Indication Function And Tripping Point
21
8.15 Command #146 Read Primary Constant And Flow Direction
21
8.16 Command #147 Write Primary Constant And Flow Direction
22