KROHNE OPTISENS COND 1200 EN - Manual (Page 26)

4
OPERATION
26
OPTISENS COND 1200
www.krohne.com 01/2014 - 4001967301 - MA OPTISENS COND 1200 R01 en
C1, process input A C1, process input A C1, process input A C1, process input A
C2, process input B
C2, process input B C2, process input B C2, process input B
Level Designation / function Settings / descriptions
Process input A and B can be either a sensor 1 or a sensor 2. Further information about the type of sensor 1 or 2 please
refer to MAC 100 manual "Sensor input combinations". Process input A is always present, process Input B can be
present.
Note: The exchange of a sensor 1 with a sensor 2, or vice versa, can only be done by the manufacturer!
Depending on the sensor which is connected to a slot A or B the menu changes.
C1.1 C1.1 C1.1 C1.1 parameter (conductivity) This menu item is for selecting the probe which is connected to process
input A/B. The entries of this selection depends on the chosen device
configuration. The device configuration is customer specific and set during
production.
C1.2 C1.2 C1.2 C1.2 cell constant Enter cell constant.
C1.3 C1.3 C1.3 C1.3 cable resistance Enter cable resistance in Ohm
C1.14 C1.14 C1.14 C1.14 time constant Enter time constant.
C1.15 C1.15 C1.15 C1.15 temperature Menu for temperature measurement. Available for sensor 1 and sensor 2.
C1.15.1 probe Options:
• manual: used if no internal or external temperature sensor is connected to
the signal converter
• Pt1000: used if an external Pt1000 temperature sensor is connected to the
signal converter
C1.15.2 manual Only available if C1.15.1 is set to "manual". If you have chosen "manual"
enter temperature.
C1.15.3 correction Offset correction for temperature measurement. Not available if C1.15.1 is
set to "manual". If you have chosen “Pt 1000” enter the temperature
correction.
C1.15.4 limitation Measuring ranges for temperature measurement. Enter limitation
C1.15.5 temp. comp. Menu for editing the temperature compensation parameters for the
measurement.
Options:
• off
• table
• ultra pure water NACl
• ultra pure water Nao3
• upw morpholin
• ultra pure water NH3
• ultra pure water HCL
• ultra pure water
• linear
C1.15.6 temp. coefficient If you have chosen “linear” enter the temperature coefficient.
C1.15.7 ref. temperature If you have chosen “linear” enter the reference temperature.
C1.15.8 Reference points Only available if C1.15.5 is set to “table”. Choose:
• 2 till 10
C1.15.9 tbl. temperature Only available if C1.15.5 is set to “table”. Choose:
• temperature for each row
C1.15.10 tbl. conductivity Only available if C1.15.5 is set to “table”. Choose:
• conductivity for each row
C1.23 C1.23 C1.23 C1.23 cell calibration For detailed information refer to calibration on page 30
C1.23.1 temp. comp. Menu for temperature measurement.
Options:
• off: temperature measurement is disabled.
• manual: temperature value has to be entered manually.
• automatic: temperature measurement is performed as configured
.book Page 26 Friday, January 24, 2014 12:32 PM