KROHNE OPTISENS COND 1200 EN - Manual (Page 12)

3
INSTALLATION
12
OPTISENS COND 1200
www.krohne.com 01/2014 - 4001967301 - MA OPTISENS COND 1200 R01 en
3.4 Pre-installation requirements
3.5 Electrical connection
CAUTION!
Never touch or scratch the sensor shaft or the inner electrode.
INFORMATION!
•
Install the sensor against the flow to ensure direct exposure of the electrodes.
• Install the sensor only in T-pieces or flow through assembly of the manufacturer.
• Avoid air getting trapped around the sensor.
• Avoid solids collection around the electrodes.
DANGER!
For devices used in hazardous areas, additional safety notes apply; please refer to the Ex
documentation.
DANGER!
All work on the electrical connections may only be carried out with the power disconnected.
DANGER!
Observe the national regulations for electrical installations!
WARNING!
Observe without fail the local occupational health and safety regulations. Any work done on the
electrical components of the measuring device may only be carried out by properly trained
specialists.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
.book Page 12 Friday, January 24, 2014 12:32 PM