KROHNE OPTISENS COND 1200 EN - Manual (Page 20)

3
INSTALLATION
20
OPTISENS COND 1200
www.krohne.com 01/2014 - 4001967301 - MA OPTISENS COND 1200 R01 en
3.7.2 Mounting to a flow through assembly
• Make sure that the plug 5 is connected to the sensor 6.
• Screw the sensor into the female thread 4 of the flow through assembly. Tighten the sensor
by hand.
WARNING!
Ensure that the pipe is without pressure before installing or removing a sensor!
INFORMATION!
The flow through assembly is an optional accessory and not part of the standard scope of
delivery. It has to be installed horizontally in pump or sample lines or directly in the process.
Figure 3-9: Possible mounting positions of the flow-through assembly
1 Mounting in an outlet pipe
2 Mounting in a bypass pipe
3 Shut-off valve
4 Sensor installed in flow through assembly
Figure 3-10: Installing the sensor into the flow-through assembly
1 Process connection
2 Protective cage
3 Flow direction
4 Female thread
5 4-pin-right-angle plug
6 Sensor
.book Page 20 Friday, January 24, 2014 12:32 PM