KROHNE OPTISENS COND 1200 EN - Manual (Page 11)

INSTALLATION
3
11
OPTISENS COND 1200
www.krohne.com 01/2014 - 4001967301 - MA OPTISENS COND 1200 R01 en
Installation
3.1 General notes on installation
3.2 Storage and Transport
• Store the sensor in its original packaging in a dry and dust-free location. Keep it away from
dirt.
• The original packaging serves the protection of the equipment. Therefore always use it for
transport or return to the manufacturer.
• Avoid solar radiation.
3.3 Installation procedure
As a new inductivity sensor needs to be calibrated before it is installed into its final measuring
location, it is important to follow the installation order:
1. Unpack the sensor.
2. Connect the sensor to the signal converter.
3. Calibrate the sensor.
4. Install the sensor into its final measuring location.
The required steps are explained in the following sections.
INFORMATION!
Inspect the cartons carefully for damages or signs of rough handling. Report damage to the
carrier and to the local office of the manufacturer.
INFORMATION!
Do a check of the packing list to make sure that you have all the elements given in the order.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
.book Page 11 Friday, January 24, 2014 12:32 PM