KROHNE UFM 610P EN - Manual (Page 5)

5
1. INTRODUCTION
The UFM 610 P is a portable flowmeter designed for use on liquid flows in full pipes, which utilise “Clamp-On” Transducers.
Easy to use with rugged packaging, the UFM 610 P features a large easy to read Graphics Display with backlighting. A simple
FAST TRACK set up procedure; Simple to follow keypad; IP65 Instrument case with IP65 rated sockets; Guide rail assembly
including magnets (if required) for steel pipes above 89mm (3½”) diameter.
Other features incorporated into the UFM 610 P are:
1) 112k memory logger
2) RS232 output
3) Pulse output
4) 4-20mA or 0-20mA output
5) 24hr Battery (rechargeable)
6) Self checking facilities
7) Battery management
8) Continuous signal monitoring
The instrument displays volumetric flow rate in M 3 /hr, M 3 /min, M 3 /sec, g/min, kg/hr, USg/hr, USkg/hr, l/min, l/sec and linear
velocity in metres and feet per second. When in flow mode the total volume both positive and negative will be displayed, up to a
maximum 12-digit number.
1.1 Fast Track Set Up Procedure
The Standard UFM 610 P is supplied in a carrying case and laid out as shown in Figure 1. Transducer sets “A” and “B” are
standard. Transducer set “C” is an optional extra. A further transducer set “D” is also available but will be supplied in a separate
carrying case. The following simple guide will enable the user to quickly set up the meter to measure flow. Additional data on
the facilities available and many useful hints are contained in the latter sections of this manual.
Figure 1
TRANSDUCER SET “B” DIAGONAL BEAM GUIDE RAIL
CABLES
TRANSDUCER SET “A”
COUPLANT
WEBBING
STRAPS
CHARGER
“C”
TRANSDUCER
SET