KROHNE UFM 610P EN - Manual (Page 10)

10
2.2 UFM 610 P parts & accessories
The UFM 610 P is supplied in a rugged IP65 carrying case. The equipment is housed in a foam insert to give
added protection for transportation.
STANDARD PARTS
Electronic instrument with backlit graphic display
Logger included as standard.
Guide Rail Assembly “A” Includes sensors for pipe ID 13mm to 89mm.
Temp. range -20
°
C to +100
°
C.
Guide Rail Assembly “B” Includes sensors for pipe ID 90mm to 1000mm.
Temp. range -20
°
C to +100
°
C.
Guide Rail for use in Diagonal Mode
Ultrasonic couplant
Power supply - with UK, US, European adapters
110/240 VAC.
Manual
Large pipe straps
4 Supplied as standard.
Sensor cables 3 metres.
Other cables 4-20mA, Pulse Output, RS232-C.
OPTIONS
Guide Rail Assembly “A”
Includes sensors for pipe ID 13mm to 89mm.
Temp. range -20
°
C to +200
°
C.
Guide Rail Assembly “B” Includes sensors for pipe ID 90mm to 1000mm.
Temp. range -20
°
C to +200
°
C.
Magnetic assembly For the Diagonal and “B” guide rail Assembly.
Transducer set “C” High Velocity Transducers for pipes 300mm-2000mm, in guide rail
“B”. Temp. range -20
°
C to +100
°
C or -20
°
C to +200
°
C.
Transducer kit “D” Sensors include ratchet straps for pipes 1000mm to 5000mm. Temp.
range -20
°
C to +80
°
C.
Straps Extra webbing straps are available on request.
Calibration certificate NAMAS accreditation.
2.3 Charger (only use the charger supplied)
The battery takes 15 hours to fully charge. When the instrument is charging but switched off the display will read CHARGING
and display a battery and plug symbol. When the instrument is in flow mode, the fact that the battery is charging will be
displayed under Battery. The instrument also displays a “plug” symbol when connected to the mains in flow mode.
2.4 Battery
When you first receive your unit put the battery on charge for a minimum of 15hrs. When fully charged the battery will last up
to 24hrs, depending on the outputs used and how often the back light is operated. If the backlight is enabled, every time a key is
pressed the backlight comes on for 15 seconds. This dramatically reduces the battery life. If the backlight was on continuously
the battery life would reduce down to 8hrs, and if the 4-20mA was used constantly at 20mA, this would reduce the battery life
by 20%. The display in flow mode continually shows the battery level as a percentage. When this indication reads
approximately 20%, it will display a warning message, at which point there is only 30 minutes of use left. The battery can be
charged while the instrument is in use or overnight while the instrument is switched off. The instrument can be partially charged
and then used.
2.5 Keypad
Programming is via the tactile membrane keypad with rim embossed keys. The keypad is rated at IP65.
Figure 6