KROHNE WATERFLUX 3070 EN - Manual (Page 42)

6
OPERATION
42
WATERFLUX 3070
www.krohne.com 06/2013 - 4001410205 - HB WATERFLUX 3070 R05 en
6.3 Menu
This chapter describes:
• How to view or change menu settings.
• A menu overview including menu access levels and default settings.
• Options for menu settings are explained in following subchapters.
6.3.1 View or change menu settings
To reset full access to the menu please refer to Reset full access to the menu on page 41.
To navigate or change menu settings follow the next steps:
CAUTION!
Access to the programming mode of the software is blocked if menu number 1 is set to 1. This is
done at the factory after the Module D verification procedure when the meter is verified
to MID Annex MI-001 or OIML R49.
Function Keys Display
To start the programming mode Hold the and the key for 5
seconds.
The display flashes.
To enter the menu Press the key within 3
seconds.
Left: menu number
Right: menu setting
To navigate through the menu to
the required menu number
Press the key.
To change the menu setting Press the key. The menu setting starts to flash.
To select the menu setting Press the key. The new menu setting starts to
flash.
To confirm the menu setting Hold the key for 3 seconds. The menu setting no longer
flashes.
To leave the programming mode
and to store the new value(s)
Hold the key for 3 seconds. The display returns to the main
screen.
To leave the programming mode
without storing the new value(s)
Do not touch any key for 60
seconds.
The display returns to the main
screen.