In-Situ Aquaculture Buoy Manual (purchased after 28 May 2013) - Manual (Page 28)

28
Set Aerators
The Set Aerators screen allows you to set ON and OFF limits for each aerator in each
pond. This screen also allows you to set minimum amperage, which is used to verify
whether or not an aerator came on or is beginning to fail. If you have purchased the
feed system software, this screen allows you to enter the feed rate and conversion
factor.
Figure 16.1 Set Aerators screen
Screen Text Description
Pond Drop-down list of all ponds
Active checkbox
When selected this indicates that the pond is in use and
designated for system control.
Buoy
Buoy number dip switch address. See "Buoy Transceiver" on
page 14.
Min DO
Use the up and down arrows to set the minimum dissolved
oxygen level that can be reached before an alert is sent.
Conversion Pounds of fish per pounds of feed
Feed Rate Pounds of feed per day per pounds of fish
Controller
Controller number dip switch address associated with the
pond, buoys, and aerators
Device Relay number (usually an aerator)
On Dissolved oxygen level at which an aerator turns ON.
Off Dissolved oxygen level at which an aerator turns OFF.
Min Amps
Set the minimum amperage below which the system will send
an alert that there is a problem with the aerator.
All Alerts Active
checkbox When selected this turns ON all system alerts for all sensors
not for just the selected pond.
SAVE Click this button to save changes to the database.
Exit
Click this button to exit without saving changes to the
database.