In-Situ Aquaculture Buoy Manual (purchased after 28 May 2013) - Manual (Page 19)

19
Programming the Radio Network Settings
1. Align the radio pins with the sockets on the programming module and press the
replacement radio into place.
2. Attach signal and power cables to the programming module.
3. Connect the cables to a computer with Digi-MaxStream software installed.
You can download the software from www.digi.com/support.
4. Go to Start>Programs>Digi>X-CTU and open the software.
5. Select the appropriate COM port for the computer you are using.
6. Select the Modem Configuration tab and scroll to the Networking section.
Figure 9.1 Digi X-CTU software, Modem Configuration tab
7. Click the following labels one at a time and enter the proper network settings: HP,
DT, MK, and SM. See page 17.
8. Click the Write button to write the settings to the new radio.
9. Click the Terminal tab to change the Modem VID.
10. All radios in a network must be set with the same VID.
11. Type +++ to put the radio into programming mode for 20 seconds.