In-Situ Aquaculture Buoy Manual (purchased after 28 May 2013) - Manual (Page 24)

24
10 Temperature—Value displayed in degrees C or F
11
VDC—The buoy battery voltage that the probe is receiving, not the actual
voltage from the battery. A value of less than 10 displays red.
12 Graph of the dissolved oxygen readings for the last 24 hours.
13
Aerators—The value is displayed in amps. They are displayed in sets of two
even if the second of the last two isn't used. When the squares are gray, the
system is in automatic mode.
Double-click on the Amp reading to switch the aerator into manual mode.
Buttons change from gray to red and green. Green turns the aerator on, and
red turns the aerator off. In manual mode, the aerator will not automatically
turn on. Double-click the value again to return to automatic mode.
A red zero indicates that the controller is not communicating with the host.
14
Page—Shows the number of the page that is displayed. The page that is
displayed cycles approximately every 45 seconds. Use the drop down arrow
to view a specific page.
15 Turn Off Alarm—Acknowledges the current alarms.
16
Scrolling Data—Shows incoming data.
A= Aerator
O=Oxygen
17
Scrolling DO readings—Click on a DO reading and this box shows the last 15
readings.