HT instruments FULLTEST3 - Manual (Page 30)

FULLTEST 3
EN - 29
5.5. RCD (RCD)
5.5.1. RCD DISPLAY EXPLANATION
Adjustable/selectable parameters:
TYPE - type of RCD
AC, A or B
CHARACTERISTIC - RCD characteristic GENERAL, SELECTIVE or DELAYED
I N - nominal differential current 10, 30, 100, 300, 500, 650 or 1000 mA
MEAS - type of measurement t /1/2I N , t /I N , t /2I N , t /5I N , I  or AUTO
POL - test current polarity POS (positive) or NEG (negative)
DELAY – delay time in DELAY characteristic 0  700 ms
Figure 17 : Display with RCD test result
1 ..... Selected function.
2 ..... Selected limit contact voltage (25 or 50 V). It can be selected in MENU
SETUPCONTACT
VOL. menu.
3 ..... Sub-results - mains voltages U L/N and U L/PE at which the test was carried out.
4 ..... Measurement screen touch-screen key.
5 ..... TYPE touch-screen key to select the type of RCD (AC, A or B) and characteristic (GENERAL,
SELECTIVE or DELAYED). Currently selected type and characteristic are displayed on the bottom
of the key.
6 ..... I N touch-screen key to select nominal differential current of the RCD (10, 30, 100, 300, 500, 650
or 1000 mA). Currently selected value is displayed on the bottom of the key.
7 ..... MEAS touch-screen key to select the measurement (t /1/2I N , t /I N , t /2I N , t /5I N , I  or AUTO ).
Currently selected measurement is displayed on the bottom of the key.
8 ..... POL touch-screen key to select test current polarity (POS - positive or NEG - negative).
9 ..... Test result (in green colour - result OK, in red colour - result not OK).
10 ... Real time clock (hh.mm.ss).
11 ... Unit of the test result (ms).
12 ... Measurement result status (symbol
in green colour - result OK, symbol in red colour - result
not OK).