GW Instek GOM-802 User Manual User Manual
Page 4
GOM-802 DC MILLI-OHM METER
USER MANUAL
⎯ ⎯
2
Temperature Compensation (Option):
The optional temperature probe PT-100 can control the measuring resistance to meet
the required temperature. When the temperature coefficient and required
temperature is keyed in under TC mode, GOM-802 will display the measuring
resistance corresponding to the required temperature.
Automatic Test:
For automatic system applications, the GOM-802 provides a handler interface that
can indicate the output status on PASS, FAIL, HI, LO, READY, or EOT, and
control signal of measurement trigger. An optional RS-232 GPIB is also available
for the computer control application.
Application:
z
Production testing for contact resistance of switches, relays, connectors,
cables and printed circuit boards and other low resistance devices.
z
Component testing of resistors, motors, fuses, heating elements.
z
Incoming inspection and quality assurance testing.
z
Conductivity evaluation for product design.
1-2. Key Feature:
z
30,000 counts.
z
Measurement Range:
30mΩ
~3MΩ.
z
0.05 high accuracy.
z
Hi/Lo comparator and limit percentage setting with 20 memory sets.
z
Measurement of REL, Actual and % value.
z
Manual or Auto-ranging.
z
Continuous or Trigger measurement mode.
z
Temperature compensation and measurement.
GOM-802 DC MILLI-OHM METER
USER MANUAL
⎯ ⎯
3
z
Four-wire measurement method.
z
Auto-recall last setting on re-power on.
z
Diode test.
z
Alarm setting for PASS/FAIL test result.
z
Sampling rate: 7 or 30 sampling/sec.
z
Standard interface: Scan, Handler, optional interface: RS-232 GPIB.