GW Instek PST-Series User Manual - Manual (Page 7)

PST-3201/3202 PROGRAMMABLE POWER SUPPLY
USER MANUAL
⎯ 8 ⎯
Figure 4-2 Rear Panel
PST-3201/3202 PROGRAMMABLE POWER SUPPLY
USER MANUAL
⎯ 9 ⎯
1. Power Switch Connect the AC power, then press power switch.
2. Display Indicate the setting of voltage/current value, output
voltage/current value and the status of setting and
output.
3. +Output Terminal Positive output terminal.
4. -Output Terminal Negative output terminal.
5. GND Terminal Connect the ground terminal to chassis.
6. Rotary Encoder Wheel knob.
7. V Set (CH1) Output voltage setting.
Switch to channel 1 by pressing [SHIFT][CH1] to
proceed group setting.
8. I Set (CH2) Output current setting.
Switch to channel 2 by pressing [SHIFT][CH2] to
proceed group setting.
9. OVP Set (CH3) Over voltage protection value setting.
Switch to channel 3 by pressing [SHIFT][CH3] to
proceed group setting.
10. F/C (STEP) Switch to wheel knob for coarse and fine
adjustment. Proceed the STEP setting by pressing
[SHIFT][STEP].
11. Recall△ (Store) Recall the next group of stored information.
Proceed information storing and editing by
pressing [SHIFT][STORE].
12. Recall▽(Recall) Recall previous stored information.
Recall the pointed stored information or set the
range to recall information automatically by
pressing [SHIFT][RECALL].
13. AUTO
(PARA/INDEP) Turn on/off automatic operation function by setting
the AUTO on or off.
Operate the instrument in the parallel mode by
pressing [SHIFT][PARA] and back to independent
mode by pressing the keys again.
14. Delay
(TRACK/INDEPT) Set the voltage and current output time in the
automatic operation mode.