GW Instek PST-Series User Manual - Manual (Page 4)

PST-3201/3202 PROGRAMMABLE POWER SUPPLY
USER MANUAL
⎯ 2 ⎯
3) Intuitional, intelligent interface window display is convenient for
user to operate the instrument.
4) High stability and low draft.
5) The function of over voltage/current/temperature protection.
6) Intelligent control fan (Vary with different output power.)
7) Warning signal by the built-in Buzzer.
8) Step by step calibration procedure.
9) Brand new panel design and the 1/2 rack size reduction volume
design.
10) Wheel knob of Fine and Coarse.
11) 100 groups storage space setting.
12) Parallel and series operation modes.
13) IEEE-488.2 and SCPI compatible command setting.
14) 0.1 sec timer for output working loop (Auto step running)
15) Correspond to CE safety regulation.
PST-3201/3202 PROGRAMMABLE POWER SUPPLY
USER MANUAL
⎯ 3 ⎯
2. TECHNICAL SPECIFICATIONS
SPECIFICATIONS PST-3201 PST-3202
Voltage 0-32V×3 0-32V×2, 0-6V×1
Current 0-1A×3 0-2A×2, 0-5A×1 Output
OVP 0-33V×3 0-33V×2, 0-7V×1
Voltage ≦3mV(≦5mV rating current>3.0A), test points are
at the + output terminal and - output terminal point.
Load Effect Current ≦3mA(≦5mA rating current>3.0A) , test points
are at the + output terminal and - output terminal
point.
Voltage ≦3mV, test points are at the + output terminal and -
output terminal point.
Source Effect
Current ≦3mA, test points are at the + output terminal and -
output terminal point.
Voltage 10mV
Current 1mA(2mA rating current>3.0A) Resolution
OVP 10mV
Voltage ≦0.05%+20mV
Current ≦0.1%+5mA(+10mA rating current>3.0A)
Program
Accuracy
(25±5℃)
OVP ≦0.05%+20mV
Voltage Ripple≦1mVrms/3mVp-p
Noise≦2mVrms/30mVp-p
Ripple & Noise
(20Hz~20MHz)
Current ≦3mArms(≦5mArms rating current>3.0A)
Voltage ≦100ppm+3mV Temperature
Coefficient
(0~40℃)
Current ≦100ppm+3mA
Voltage 10mV Readback
Resolution
Current 1mA(2mA rating current >3.0A)
10%~90% ≦100ms
Response Time
Voltage Up
Voltage Down
90%~10% ≦100ms (≧10% rating load)
Voltage ≦100ppm+10mV Readback
Temperature
Coefficient
Current ≦150ppm+10mA
Voltage ≦100ppm+10mV
Drift
Current ≦150ppm+10mA