GW Instek PST-Series User Manual - Manual

PST-3201/3202 PROGRAMMABLE POWER SUPPLY
USER MANUAL
⎯ ⎯
i
CONTENTS PAGE
1.
PRODUCT INTRODUCTION.................................................
1-1. Description………………………………………………
1-2. Feature…………………………………………………... 1
1
1
2. TECHNICAL SPECIFICATIONS………………………… 3
3. PRECAUTIONS BEFORE OPERATION…….…………...
3-1. Unpacking the Instrument……………….………….….
3-2. Checking the Line Voltage…………………..………….
3-3. Environment……………………………………..……... 5
5
5
6
4. PANEL INTRODUCTION……………………..…………... 7
5. OPERATION METHOD………………………………...….
5-1. Output Voltage/Current Setting…………………..……
5-2. Over Voltage/Current Protection Setting……………...
5-3. Voltage/Current Step Setting…………………………..
5-4. Information Storing & Recalling Setting………………
5-5. Information Editing & Copying Setting……………….
5-6. Auto Operation Mode….……………………………….
5-7. Parallel Operation Mode…………………………….….
5-8. Track Operation Mode…………………………………
5-9. GPIB/RS-232 Interface Setting…………………………
5-10.The Maximum Output Setting………………………....
5-11.Test Lead………………………………………………..
5-12. The Setting of the GPIB and RS232 Interface……….. 11
11
12
13
13
15
16
17
17
18
19
20
20
6. MAINTENANCE………………………..…………………..
6-1. Fuse Replacement……………………………………….
6-2. Line Voltage Conversion………………………………..
6-3. Adjustment and Calibration……………………………
6-4. Cleaning………………………………………………… 21
21
21
22
28
7. THE SYSTEM DIAGRAM AND DESCRIPTION………..
7-1.Block Diagram…………………………………………...
7-2.The Operation of the whole circuit……………………... 29
29
30
PST-3201/3202 PROGRAMMABLE POWER SUPPLY
USER MANUAL
⎯ ⎯
ii
SAFETY TERMS AND SYMBOLS
These terms may appear in this manual or on the product:
WARNING. Warning statements identify condition or practices that
could result in injury or loss of life.
CAUTION. Caution statements identify conditions or practices that
could result in damage to this product or other property.
WARNING: This equipment is not for measurements performed for
CAT II, III and IV.
Measurement category I is for measurements performed on circuits not directly
connected to MAINS.
Measurement category II is for measurements performed on circuits directly
connected to the low voltage installation.
Measurement category III is for measurements performed in the building
installation.
Measurement category IV is for measurements performed at the source of the low-
voltage installation.
The following symbols may appear in this manual or on the product:
DANGER ATTENTION Protective Earth (ground) Frame or Chassis
High Voltage refer to Manual Conductor Terminal Terminal
Terminal