GW Instek GDS-200 Series Quick start guide - Manual (Page 16)

Trigger
Source
Ch1 or Ch2
Trigger Mode Auto, Normal, Single, Force
Trigger Type Edge, Pulse width, Video,
Alternative
Trigger Holdoff 10ns - 10s
Coupling AC, DC, LFR, HFR, NR
Sensitivity DC - 25MHz: approx. 0.5div or
5mV
25MHz - 70/100/200MHz:
approx. 1.5div or 15mV
Horizontal
Range
5ns-100s/Div (1-2-5
increments)
Roll 100ms/div - 100s/div
Pre-Trigger 10 div max.
Post-Trigger 1,000 div max (depend on time
base)
Accuracy ±20ppm over any > 1ms time
interval
X-Y Mode
Phase Shift
±3° at 100kHz
Cursors and Measurement
Cursors
Voltage difference between
cursors(△ V), time difference
between cursors(△ T),
frequency measure(1/△ T)
Auto-measurement 36 sets
Auto-counter 6 digits. Range: 2Hz to rated
bandwidth
Autoset Available
Probe Compensation
2V, 1kHz, 50% Duty cycle