Fire-Lite ACC-25/50DAZS Distributed Audio Panel - Manual (Page 27)

Distributed Audio Panel Manual — P/N 52265:B1 6/8/2010 27
S1 DIP Switch Settings on Distributed Audio Motherboard Field Programming
The following table details which audio sources will be transmitted depending on the conditions
stated above and the number of messages that can be recorded along with the duration of each mes-
sage.
S1 DIP Switch Settings
for Switches:
Message
Length
FC-MGM
Audio Signal Control 1, 2
7 8 CMD1 3, 4 CMD2 CMD3 CMD4 CMD5
0 0 Tone Only 5
(no message)
Riser to
AAM1& 2
Tone to
AAM1 & 2
0 0 60 sec. Riser to
AAM1 & 2
message1 to
AAM1 & 2
1 0 30 sec. Riser to
AAM1 & 2
message1 to
AAM1 & 2
message2 to
AAM1 & 2
0 1 20 sec. Riser to
AAM1 & 2
message1 to
AAM1 & 2
message2 to
AAM1 & 2
message3 to
AAM1 & 2
1 1 15 sec. Riser to
AAM1 & 2
message1 to
AAM1 & 2
message2 to
AAM1 & 2
message3 to
AAM1 & 2
message4 to
AAM1 & 2
Table 2.2 DIP Switch S1, Switches 7 & 8
1 This table is only valid for ACC-25/50DA configurations. The CMD1 through 5 inputs are ignored by
the ACC-25/50DAZS, which is controlled, instead, via the Zone System serial link from the ACC-
25/50ZS/T. CMD3, CMD4, and CMD5 still require End-of-Line resistors.
2 The ACC-25/50DAZS supports local message generation for backup purposes only. All voice
messages are input from the ACC-25/50ZS/T panel.
3 CMD1 has the highest priority, CMD5 has the lowest priority.
4 CMD1 does not open for trouble conditions when configured as an ACC-25/50DAZS
5 Tone Only is the factory default setting. If the FC-MGM module is not installed, this configuration
provides tone only.