Edwards Signaling 48 Series - Manual (Page 3)

P-047550-1448 ISSUE 10
Figure 3. Lamp Replacement
Replacement Parts
Component Catalog or Part Number
Halogen Lamp - 48SIN(*)-N5-25WH, 48FIN(*)-N5-25WH 50LMP-25WH or
Industry Trade No. 15T7DC**
Halogen Lamp - 48SIN(*)-G1-20WH, 48SIN(*)-G5-20WH, 50LMP-20WH or
48FIN(*)-G1-20WH, 48FIN(*)-G5-20WH Industry Trade No. 1692**
Incandescent Lamp - 48SIN(*)-E1, 48FIN(*)-E1 Industry Trade No. 94
Lens (Amber, Blue, Clear, Green, Magenta or Red) - 48FIN and 96-L(*)
48SIN Series
Lens (Amber, Blue, Green, Red) - 48FLED and 48SLED Series 96-L(*)
*Specify color of lens by adding one of the following letters to the catalog number: A-amber, B-blue,
C-clear, G-green, M-magenta, or R-red. Example: A red lens for the 48SIN series signal is 96-LR.
**The non-halogen bulb listed may be used in the halogen bulb models.
1. Insert a small flat blade screwdriver between the locking
mechanism and the lens. Gently push down and then pry up,
unseating the lens. Pull the lens up and off of the signal
mounting base.
2. Gently push down on the lamp, twist and pull up to remove
the lamp from its socket. Install the new lamp by aligning
the connector on the base of the tube with its mating socket,
then carefully press down into the socket. Assemble the
signal.
3. Apply power to the signal and verify that the signal operates
properly.
WARNINGS
To prevent injury, do not remove or insert lamp
when unit is energized.
To prevent leakage and potential electrical shock,
use care when disassembling the signals to
prevent tearing of the weatherproof gaskets.
timum light visibility. Ensure that the lens is completely dry
before assembling the signal.
Lamp Replacement (non-LED models only)
CAUTION
To prevent property damage and injury, do not
touch glass with bare fingers. Grasp glass with a
soft, clean cloth or with packaging supplied with
the replacement lamp.
Refer to the "Replacement Parts" section, for the required type of
lamp. After disconnecting power, replace the lamp as follows:
Refer to Figure 3.