Edwards Signaling 5532M - Manual (Page 3)

P/N 3100010 • REV 7 • ISS 04AUG10 3 / 10
c. For the tone generator, select the appropriate
method for wiring to the input board from Figure 7 -
Figure 12. Connect the tone generator as shown.
d. Connect incoming power to wire leads using a butt
splice or other method listed, certified, or otherwise
approved by local authorities. Leads are both black
for -AQ and -N5 models and are black and white for
-Y6 models.
e. Optional. Connect external 24 VDC battery (not
supplied) in series with separate diode assembly
part 2600010 (supplied) to TB1 terminals 3 and 4
on the main board as shown in Figure 2 and
Figure 3 and marked on the diode assembly.
NOTE: Terminal Block TB1 can be unplugged from the
main board to complete wiring as shown in Figure 2 and
Figure 3.
3. Wire to the 5532B series speaker/amplifier as follows
and referring to Figure 4 - Figure 6 and Figure 17:
If Edwards signal actuator, catalog number 5538-4, is
used to manually initiate tones, connect its four
normally-open switches to the tone generator as shown
on instructions provided with the signal actuator unit.
a. Connect green earth-ground wire of
speaker/amplifier and green and yellow striped
earth-ground wires on tone generator to earth-
ground.
b. Connect audio output (+) from the main board of
the tone generator to the Tone In terminal 9 (+) in
the speaker/amplifier. Connect audio output (-)
from the main board of the tone generator to the
Tone In terminal 10 (-) in the speaker/amplifier. Up
to 2500 speaker/amplifiers can be so connected in
parallel to a single tone generator.
c. For the tone generator, select the appropriate
method of wiring to the input board from Figure 7 -
Figure 13. Connect the tone generator as shown.
d. For 5532B-AQ, 5532BDV2-AQ and 5532BHV-AQ
models, connect power source to the
speaker/amplifiers at TS2. Polarity must be
observed for DC models.
e. For 5532B-Y6, 5532BDV2-Y6, 5532BHV-Y6, and
5532B-N5 models, connect incoming power to wire
leads from power supply. For -Y6 models using a
DC source, black wire is positive and white is
negative and polarity must be observed. For AC
source, black is line and white is neutral.
f. For tone generator, connect incoming power to wire
leads using a butt splice or other method listed,
certified, or otherwise approved by local authorities.
Leads are both black for -AQ and -N5 models and
are black for line and white for neutral for -Y6
models.
g. Optional. Wire 24 VDC battery backup to TS1-1
and TS1-2 of the speaker/amplifier per Figure 17
and connect 24 VDC battery backup in series with
diode assembly part 2600010 (supplied) to TB1
terminals 3 and 4 on the main board of the tone
generator per Figure 2 and Figure 3. Polarities
must be observed.
NOTE: Terminal block TB1 can be unplugged from the main
board of the tone generator to complete wiring.
Maintenance and testing
WARNINGS: To prevent fire, shock and component
damage, NO work, including circuit board removal, should
be performed while the circuit is energized.
NOTE: Any kind of service or maintenance performed
while unit is energized will void the warranty.
Examine the unit semi-annually for accumulation of dirt.
Clean if necessary.
The Adaptatone should be tested annually or as required by
the authority having jurisdiction to ensure continuous
service.
Figure 1: Mounting the Adaptatone
Figure 2: Terminal block TB1