Triton 9621 Operation Manual - Manual (Page 175)

6-3
S
INGLE
-C
ASSETTE
C
ASH
D
ISPENSER
O
PERATION
M
ANUAL
T
RITON
S
YSTEMS
, I
NC
.
S
ECTION
6 - M
AINTENANCE
M
ODELS
9600/9601/9620/9621
R
EPLENISHING THE
R
ECEIPT
P
APER
NOTE:
This operation can be completed with the
AC Power applied to the Cash Dispenser
1. This operation can be completed with the
power on. Open the top of the cash dispenser
by unlocking the top enclosure and pulling
the hinged door forward.
2. Remove any paper that remains in the paper
path as follows:
a. If paper remains on the roll, cut the pa-
per between the roll and the printer with
a pair of scissors as shown in Figure 6-2.
Use the RECEIPT PRINTER PAPER
FEED BUTTON (Figure 6-3) to feed the
paper through the paper path until all pa-
per comes out the front of the printer.
NOTE:
Do not pull the paper backward through
the printer. This may leave paper frag-
ments that can cause paper jams.
Figure 6-2. Cut any paper between the roll and
the printer feed path with scissors.
Figure 6-3. The PAPER FEED
BUTTON.
FEED BUTTON
**NOTE**
The top enclosure access door is provided with
a pneumatic piston to prevent the door from
extending too far when opening and from being
closed too quickly. In the unlikely event of the
pneumatic piston not functioning properly, the
door should be prevented from opening too far
and from being slammed when closing.